V2000-c Rfid Access Control User Manual Jun 2026

: The V2000-C is a NON-PoE device. Do not connect the device to a PoE capable Ethernet port as this may cause permanent damage.

Note: Factory default is 5 seconds. Set to 0 for a toggle switch action. 4. User Management: Adding and Deleting Users

Never leave the default system password active. To change it: Enter Programming Mode. Press 0 . Enter your , then press # . V2000-c Rfid Access Control User Manual

The V2000-C is a single-door multifunction standalone access controller. It supports up to and allows access via RFID card, a 4-to-6 digit PIN, or a combination of both. Operating Voltage: DC 12V ± 10% User Capacity: 2,500 Card Reading Distance: 3–6 cm Active Current: Lock Output Load: Max 3A Operating Temperature: -45°C ~ 60°C 2. Installation and Wiring

If you’d like, I can:

The V2000-c is a standalone access control keypad that utilizes RFID card technology and a numeric keypad for secure entry. To ensure proper setup, please verify the following technical specifications:

Installing and configuring the V2000-C RFID access control system requires careful planning and attention to detail. Here are the general steps involved in installing and configuring the system: : The V2000-C is a NON-PoE device

End of Report