While the LNL-3300-M5 can be configured through its embedded web server, some settings for downstream modules are managed via DIP switches. For example, the LNL-1320-2RP Reader Module uses on-board DIP switches to set its device address and baud rate.
The LNL‑3300‑M5 supports , meaning new firmware can be transferred to the controller without taking the access control system offline. The firmware is stored in flash memory, and the controller continues to operate normally during the download process.
Installation Guide for the Lenel OnGuard LNL-3300-M5 Intelligent System Controller
: Remove the legacy boards and insert the LNL-3300-M5 into the backplane . It replaces the legacy CPU (E, P, PX, PXN, or PXNplus) and the Power/Comm Board (PN: 110064001) . Lenel Lnl-3300-m5 Installation Manual UPD
LED Indicators: If the Status LED flashes rapidly, the board may be in an error state or waiting for a firmware update.Communication Loss: Verify that the Ethernet cable is secure and that the network firewalls are not blocking the required ports (typically port 3001).Memory Reset: If the board becomes unresponsive, use the onboard reset button to clear the memory and restore factory defaults. Maintenance and Updates
Solution: Verify LED 4 is lit. Ping the panel's IP address from the OnGuard communication server. Check if DIP switch S2 position 2 was left ON by mistake, forcing the default IP address.
Within minutes, he had assigned a static IP that would talk to the building’s via the onboard 10/100 MB Ethernet port. The Result While the LNL-3300-M5 can be configured through its
Once the hardware is in place, it's time to connect power, ground, and all necessary peripherals.
Gently depress the board onto the snap-on spacers until it clicks into place. Secure any dedicated ground wires to the earth-ground lugs of the main cabinet housing. Electrical Wiring & Port Connections
Connect the RS-485 data wires to Port 2 to interface with downstream reader modules or expansion boards. Maintain consistent twisted-pair polarity throughout the bus. Configuration and Addressing The firmware is stored in flash memory, and
Insert a standard Cat5e or Cat6 Ethernet cable into Port 1 (RJ-45). Connect the other end to your dedicated security network switch.
The Lenel Lnl-3300-m5 Installation Manual typically consists of several sections, including:
The "UPD" in the title "Lenel Lnl-3300-m5 Installation Manual UPD" suggests that the manual has been updated. The UPD section may include:
Save the panel configuration. Right-click the newly created panel in the communication status monitor and select Download (ensure you check options for "Cardholders", "Operating System", and "Database"). 5. Troubleshooting and Diagnostic LEDs