9240si Loop Controller User Manual ((exclusive)) Jun 2026

Tighten the screws evenly until the unit is securely anchored. Do not overtighten. 3. Wiring and Terminal Connections

A: The 9240SI is a specialized test device that outputs a specific electrical signal. While it is referred to as an "AC meter" in some maintenance manuals, it is a purpose-built tool, not a general-purpose multimeter.

Connect the two common-colored wires to Terminals 5 and 6, and the single remaining wire to Terminal 4 for a standard 3-wire compensation setup. 9240si loop controller user manual

Increase this value to reduce overshoot, though it increases time to target.

Accessed by holding the SET key for 3 seconds. Contains basic scaling, sensor type matching, and alarm limits. Tighten the screws evenly until the unit is

Internal memory corruption. Perform a factory reset by holding the UP and DOWN keys simultaneously during power-up.

The terminal block on the rear panel is numbered 1 through 24. Always reference the wiring schematic printed on your specific unit shell before completing connections. Wiring and Terminal Connections A: The 9240SI is

Some notable highlights of the manual include:

What you are using (Thermocouple, RTD, or 4-20mA)?

Dampens system overshoot by predicting errors. Range: 1 to 900 seconds. Set to 0 to disable.