Lg K41s | Isp Pinout New

For further assistance, technicians often share updated diagrams on platforms like the Global Fix Central Facebook Group or specialized forums like GSM-Forum . Lg ms330 ISP PINUOT DONE al soporte de Easyjtag - Facebook

Set the voltage frequency to or manually select 1.8V for VCCQ and 3.3V for VCC .

To expose these points, you must disassemble the phone and remove the motherboard shieldings near the MediaTek processor and eMMC chip. Look for the small copper test points (tracks) on the PCB layout. You need to solder jumpers to exactly four signal lines: 1. DAT0 (Data 0) lg k41s isp pinout new

I’m not sure what you mean by “produce an feature.” I’ll assume you want the ISP pinout for the LG K41S (for hardware repair or flashing) and a short feature list; I’ll provide both.

| Signal | Component Pad | | :--- | :--- | | CLK | One side of (0 ohm jumper) | | CMD | One side of R502 | | D0 | One side of R503 | Look for the small copper test points (tracks)

Located on an exposed test point pad directly under the shielding GND Any major copper shield, ground plane, or screw hole GND VCC ( )

Apply flux, tin the test points, and solder thin wires (max 3cm length). For DAT0, solder to the positive side of resistor R131 (near the EMMC). Solder ground to any unpopulated screw hole. | Signal | Component Pad | | :---

Perform this at your own risk. Improper soldering or incorrect voltage can destroy the motherboard.

| Feature | Old Pinout (Rev 1.0) | New Pinout (Rev 1.1) | |-----------------|----------------------|------------------------| | CLK location | TP611 | TP610 | | CMD location | TP609 | TP622 | | D0 location | TP603 | TP603 (unchanged) | | Pull-up required? | No (internal 50k) | Yes (external 4.7k) | | Success rate | 30% (unstable) | 95% (stable) |

: Shorten the length of the CLK jumper wire or lower the clock frequency inside the tool interface down to 9 MHz .