Turn the power switch of the Satlink WS-6906 immediately.
The Satlink WS-6906 supports software upgrades via two interfaces:
only supports . A software upgrade cannot enable it to receive DVB-S2 (HD) signals, as this is a hardware limitation. Satlink WS-6906 Software Upgrade Guide | PDF - Scribd
Connect the RS-232 cable to the finder and your computer’s motherboard or USB port. Initialize Software: SatlinkTools satlink ws-6906 software upgrade
Before proceeding with any software update, be aware of a potential incompatibility issue. , and the firmware from the first version does not work on the newer WS6906 device. Using the wrong firmware after an upgrade may lock your newer Satlink model, leaving it unable to scan or receive any signal.
. Once finished, the meter will automatically restart to apply the new software. Updating Satellite Data (Optional)
If you only need to update satellite names and transponder lists (not the operating system), use this method. Turn the power switch of the Satlink WS-6906 immediately
Satlink's official PC loader software (typically Upgrade.exe or STB_Loader ).
When the program displays a status like "CHECK SERIAL PORT STATUS," .
What are you trying to fix with this upgrade (outdated satellites, freezing, etc.)? Share public link Satlink WS-6906 Software Upgrade Guide | PDF -
The official method using the device's USB port, which is straightforward when the original USB cable is available.
Connect the WS-6906 to your PC via USB while holding the "Power" button . The PC should detect an "ATMEL" or "Rockchip" device. Install the provided PL2303 or CP210x drivers.
Once detection is confirmed, click to begin writing the new update to your WS-6906. The update typically takes about one minute to complete. Do not disconnect any cables or power off the device during this period.
Launch the ( Upgrade.exe ) on your PC as an Administrator.