Kincaid Radio Controlled Clock Instruction Manual [cracked]

Keep holding the button; the hands will begin to move forward.

: Place a fresh AA alkaline battery into the compartment.

(Pacific), MT (Mountain), CT (Central), and ET (Eastern).

Place the clock on a flat, stable surface. Do not hang it on the wall until the initial synchronisation is complete. Step 2: Select Your Time Zone (For Digital Models) kincaid radio controlled clock instruction manual

To properly initialize your Kincaid clock, follow these sequential steps:

If you live inside a building with a metal frame, concrete walls, or aluminum siding, the signal may struggle to penetrate. Position the clock as close to an exterior wall or window as possible.

Low battery voltage. When batteries begin to fail, the radio receiver becomes inefficient, and the mechanical gears lack the power to rotate the hands correctly. Keep holding the button; the hands will begin

: The clock will typically exit manual mode automatically if no buttons are pressed for 6–10 seconds. www.american-time.com Troubleshooting and Tips

: Keep the clock at least 6 feet (2 meters) away from electronic appliances like TVs, computers, or microwaves that may disrupt the radio signal.

Even the best atomic clocks can fail to sync. Here is the official Kincaid troubleshooting matrix. Place the clock on a flat, stable surface

Press and hold the or REC button on the back of the clock for 3 to 5 seconds.

: Hold the button for rapid movement or press it repeatedly for minute-by-minute adjustments.

| | Solution | |---|---| | Poor signal location | Move clock to a different room near an exterior north-facing window | | Local interference | Unplug all electronics within 3 feet of the clock | | Wrong time zone setting | Check the P/M/C/E switch on the back | | You live too far from Colorado | Manual sync may only work 75% of the time in coastal areas. Try a forced sync at 2:00 AM. |