The "hardware information does not match with your dongle" error in Autodata 3.45 can be resolved by troubleshooting the dongle and software configuration. By following the step-by-step solutions outlined in this article, you should be able to resolve the error and continue using Autodata 3.45 to diagnose and repair vehicles. If you're still experiencing issues, don't hesitate to contact Autodata support or the dongle manufacturer for further assistance.
PleaseIf you are stuck, sharing your and whether you see any accompanying Runtime errors will help target the next steps. Share public link
: Some errors are linked to missing or unregistered system files. Open Command Prompt as Administrator and run the following command to register a key component: The "hardware information does not match with your
Before diving into complex solutions, start with this systematic checklist. Following these steps in order can often resolve the issue without a full reinstall.
: Verify that Windows is in "Test Mode." If it isn't visible in the lower right corner, you may need to disable Secure Boot in your BIOS or manually enable it via the command prompt. PleaseIf you are stuck, sharing your and whether
Following these cleanup steps aligns your system's hardware reporting parameters with the application's expectations, resolving the dongle authentication error.
The "hardware information does not match with your dongle" error in Autodata 3.45 can occur due to several reasons: Following these steps in order can often resolve
Run the hardware identifier tool (often named GetID.exe , chklnk.exe , or HardwareID.exe ) as an Administrator.
To avoid encountering this error in the future:
Open the command prompt with Administrator privileges. Step 2: Type bcdedit /set testsigning on and press Enter.